CSM Sync with diff

[Zarahelll]

Good morning

Is there any way or CSM configuration of synchronizing the configs between an active and standby CSM, where the active CSM will perform a diff between its configuration and the standby's one?

The ideia is to configure the active CSM, and afterwards perform a hw-module csm X  standby config-sync (or similar), where instead of replicating all the CSM's configuration into the standby CSM, it will only add the new configurations on the standby CSM (let´s say a new sfarm or probe, or whatever).

[Gilles Dufour]

no, this is not possible with the CSM.

The ACE module does that but there is no plan to do the same for the CSM.

Gilles

[Zarahelll]

Gilles Dufour

Thanks for your reply.

Is this the standard behaviour for the ACE's sync, or does it require addicitional configuration?

If so, what configuration do you need to implement?

[Gilles Dufour]

The ACE module does the diff synch by default.

You activate config synch with the following command :

AceC6k2/Admin(config)# ft ?
  auto-sync        Enable auto sync

Configuration is synched automatically when you type it on the active.

Gilles.