12-15-2010 03:19 AM
Good morning
Is there any way or CSM configuration of synchronizing the configs between an active and standby CSM, where the active CSM will perform a diff between its configuration and the standby's one?
The ideia is to configure the active CSM, and afterwards perform a hw-module csm X standby config-sync (or similar), where instead of replicating all the CSM's configuration into the standby CSM, it will only add the new configurations on the standby CSM (let´s say a new sfarm or probe, or whatever).
12-15-2010 08:10 AM
no, this is not possible with the CSM.
The ACE module does that but there is no plan to do the same for the CSM.
Gilles
12-15-2010 08:33 AM
Thanks for your reply.
Is this the standard behaviour for the ACE's sync, or does it require addicitional configuration?
If so, what configuration do you need to implement?
12-15-2010 09:35 AM
The ACE module does the diff synch by default.
You activate config synch with the following command :
AceC6k2/Admin(config)# ft ?
auto-sync Enable auto sync
Configuration is synched automatically when you type it on the active.
Gilles.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide