CSS 11500 Serial Management Port Parameters

[sfalbe]

How to change / check the baud rate, parity, and stop bits of the serial management port.

My PC is currently set to 9600,8,1,N and I am receiving garbage. Telnet is ok

Thanks,

Steve

[mschnabe]

I dont think you can change the port parameters -

Connect a console to the Console port on the CSS. Configure the console with

the following default values: 9600 baud, no parity, 8 data bits, 1 stop bit, and

flow control set to None. This is from the appendix B of the 7.10admin

[Gilles Dufour]

be carefull that the cable for console access is different from any other Cisco device. So, if your cable works for a Cisco router or a Cisco switch, than this is the wrong cable for the CSS.

If you search www.cisco.com for 'css console pinouts' you should find the right settings.

Gilles.