Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi friends,
I'm trying to configure the DNA with the Cisco 9300. Please do you have a guide on how to do it, as the configuration doesn't seem very user-friendly.
I'll be waiting.
Hi Guys,Wanted to know what was the preferred or Cisco accepted way to install / configure multi-tier certificates on the SSL module? When reading the config guide, it discusses in detail how to handle a single tier cert (i.e just a root ca cert), h...
Hi Community,We have recently installed new N2K-C2348UPQ-10GE FEXs, however they are not coming online.The interface is showing :Ethernet1/21 is down (SDP timeout/SFP Mismatch)and the fex logs: [26209]04/21/2026 21:27:31.692130: fport [0x1a014000]:L...
Good DayI have a pair of C8200L devices racked and online.These will be running a redundant Call Manager Express install.First I am told I must configure Box-to-Box redundancy.I navigate here but find this document unusable:Home > Support > Product ...
Hello Expert ,We are replacing the N3K device with N9K .We could see N3K has LAN_BASE_SERVICES_PKG license whereas in new N9K device there is no license ..Will this have any problem after the switch replacement ?N3K : N3K-C3048TP-1GE ...
CP 8841, CP 8811 Authentication Failure, new ip phone, when i open authentication from switch port configuration its working, with authentication its not working , status showing unauthentication.
hiI have a customer with 4710 that load balances inbound traffic onto 2 servers. this worksThere is also a requirement for the servers that are load balnced to [what seems to me ] to load balance onto themselves and for other server on the same vlan ...
Hi, I'm looking for ECCN, HTS/EU Taric codes for the following products:
- CW9172I-CFG
- C9300-48UN-E & C9300-48UN-A
- C9300-NM-8X
- C8200-1N-4T
- C9300LM-48UX-4Y-E & C9300LM-48UX-4Y-A
Can anyone help me on this?
Hi,
I have a line card (A9K-24X10GE-1G-TR) that has gone down and needs to be replaced. At the moment, there is no service outage.
Could you please provide me with the proper procedure to install the replacement part?Will the firmware need to be upda...
Hello,I'm trying to setup a pretty simple solution for web servers load balancing using ITD on Nexus 93108TC-EX with NX-OS 10.3(6)M.There is a Deployment guide for Direct Server Response (ITD Service), and I'm following it with 3 exceptions:Ingress ...
I had a really old DNA sitting on a shelf since before COVID that i just plugged in.I got the CIMC setup and i ran the Maglev Wizard and i do believe it completed (finished after work hours).If i log into the CIMC and Launch the KVM is get a "Welcome...
