694
Views
0
Helpful
1
Replies
CSS11506 Good Show commands to validate failover
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-28-2012 12:22 PM
Hello All,
I am planning to perform a failover drill between active and standy CSS loadbalancers which are configured in a cluster pair. I am looking for help to know what show commands I can run to validate that the failover occurred successfully from primary to secondary load balancer and that the VIP's have failed over successfuly as well.
Any guidance you can provide on this would be greatly appreciated.
Thanks,
Adil
Labels:
- Labels:
-
Application Networking
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-28-2012 12:39 PM
Hi Adil,
You can use:
# sh virtual-routers
If you have configured VIP/Int
If you have Box-to-Box:
# show redundancy
---------------------
Cesar R
ANS Team
---------------------
Cesar R
ANS Team
