Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Low DRE comrpession detected for serverI am getting this warning on one of my WAAS appliances. Has anyone else seen this? This is on a WAE 502 device running v5.0.1The mispelling of "comrpession" is a copy and paste from the warning message Thanks
Hi,I'm currently seeing the counters for the 'Total Connections Failed' statistic increasing by a large amount. What I can't see is why. The serverfarms we have don't see to show any drops.Using ANM 5.1 we also see this under 'Monitor' 'Load Balancin...
Good morningWe have many instances of configuration across many ace devies where we source nat traffic that is on the server side vlan of the ace module. All of the vips in these examples are for tcp 80 or tcp 555 or tcp 443 etc etcThey are configur...
HI all,Our WAAS Manager had a HDD failure. The drive was replaced, and is now obviously a blank manager, is there a way I can import the config from the WAVE devices?
Hello, I'm configuring ACE 4710's for the first time and I want to load balance my Nuance speech servers on port 554. Here's my configuration on ACE01:hostname ace471001interface gigabitEthernet 1/1 switchport access vlan 1000 no shutdowninterface ...
Hi,Can anybody help me to know the use of "action rewrite" command:policy-map type loadbalance first-match XXXXXclass class-default serverfarm YYYYYYYaction REWRITERegards,Thiyagu
I have a GSS 4490 but only want it to be authoratative for certain hosts. Sysadmins don't want to lose control of their DNS records.How do I point active directory to the GSS to look up the host?I need to keep the AD domain as authorative for the DNS...
Guys,I would like to know if allowing vlans under portchannel will replicate on standby unit.Somehow I see all configuration is sync except switchport trunk allowed vlan under Portchannel. ThanksAjay
Hello All,I am planning to perform a failover drill between active and standy CSS loadbalancers which are configured in a cluster pair. I am looking for help to know what show commands I can run to validate that the failover occurred successfully fr...
I am trying to configure WCCP on my Routers in a DMVPN environment, in order to setup WAN Optimization. The issue is as soon as i activate the WCCP service on my ASR or any router at my remote sites with either 'ip wccp 98 group-list ACL' or 'ip wcc...
I am running version 5.0.1My company has recently started deploying Office 2010 with Outlook 2010. In troubleshooting slow performance in one of my locations, I found that traffic from the mail server was overloading the circuit. On the WAAS, I hav...
Hi,I need the MIB object names for monitoring the processor and Memory Utilization of CSS 11503 with software version 7.50 Where can I find it?Expecting your assistance.with regardssathappan
Hi,I've configured parameter-map with "set inactivity timeout 0" but the http session is still timing out.I applied that "set inactivity timeout 0" parameter map to the policy-map than applied that policy map service policy to the interface but http ...
