10-10-2010 11:43 PM
Hello, Sir/Madam,
I have seen a good document for fail-over redundancy of ACE modules.
Now, I know that how Stateful failover is supported across two Cisco Catalyst 6500 Series chassis.
But I do not know how Stateful failover is supported within a Cisco Catalyst 6500 Series chassis.
May I have your suggestions for this question? (configurations)
I guess I can configure the same way that mentioned above url in another ACE appliance even though those are within a single Chassis.
Am I right?
Thanks a lot in advanced.
Regards,
Lim
Solved! Go to Solution.
10-11-2010 01:05 AM
Hi Seok-Bin,
HA is supported also within the same Cat6k.
As you correctly said, the configuration is exactly the same, so feel free to follow the one from the URL you mentioned.
Cheers,
Domenico.
10-11-2010 01:05 AM
Hi Seok-Bin,
HA is supported also within the same Cat6k.
As you correctly said, the configuration is exactly the same, so feel free to follow the one from the URL you mentioned.
Cheers,
Domenico.
10-11-2010 04:25 PM
Thanks a lot,
I feel free now,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide