i am trying to use teh ACE to replace an apache based load balancer in an jboss application cluster. I am using L7 loadbalancing to load balance between multiple components. the way these jboss application servers work with apache is that ---
When the jboss application starts up on the on application cluster, it issues a GET opencase/webservices/config-service?wsdl to the loadbalancer IP
The apache based LB in turn talks to the same box on port 8009 via ajp retrieves the configuration file and provides it back to the application on port 80
And after 2 has completed the Jboss application comes up. Basically to start the application the Apache loadbalacer will accept requests from the its target list and load balance the request back to them itself
Not sure how i can use the ACE to accomplish this.
attached are my topology (logical) and the ace configuration. from my topology file -- the net-cms-1 will issue a get request to teh VIP (on the ace), the ACE accepts the connection but soon resets it.
How does everyone feel about service graphs in a brownfield network centric cutover? maybe I'm an old school engineer but I was taught that if you have to do a Pbr then your design is wrong. they are a pain to troubleshoot because you always f...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Going to Cisco LIVE EMEAR 2020? Give your Data Center agenda a boost with these top recommended sessions. Register and join us!
Data Center Networking:
From Reactive to Proactive NetOps With Cisco Network Assurance and Insights- The Power of Data...
Hi allWe're trying to tackle a DHCP relay problem between a set of N9K-C9332PQ (NXOS 9.3.2) and dnsmasq (doesn't work) resp Windows 2016 DHCP service (works with some tweaking).SITUATION:We have a BGP EVPN VXLAN (L2VNI and L3VNI) with anycast gateway setu...