Application Networking

             Our core WAE 7326 is reaching its  connection limits, also we cannot upgrade from current 4.3.3 to a 4.4 OS as not supported. So would want to move the 7326 out to a remote site, and get a new WAVE-7541 for the core site, I know in the d...

Hello AllI have an ongoing issue where adding stickness to a vserver on our csm causes the website to take 3 to 4 minutes to load.  If I remove stickyness from the VIP then the website loads instantly.  We have tested this many times and get the same...

Hi,I want to route gre traffic through an ACE20, but it doesn't seem to work. The only thing I configured was an ACL with gre enabled, but the ACE20 seems to drop the gre packtes. The gre traffic is entering via the vlan 561 interface and should be s...

Hi teami am trying to use teh ACE to replace an apache based load balancer in an jboss application cluster. I am using L7 loadbalancing to load balance between multiple components. the way these jboss application servers work with apache is that ---W...

Hi, We have several probes configured for our serverfarms. Some of the probes and rservers are alerting for timeouts or regex's not found etc.What's the best way to check if this is a rserver or probe problem ? Using captures ?Or is it possible to ...

I have most of my ssl inbound connections working except for 1 backend server that refuses to co-operate and I think the issue is my class map match all statement.The ssl flow works fine thru our old CSS with this config                   content dec...

Hi,we use ACE30 module, ver. A4(1.0) for access to intranet application.The https connection from client is terminated on ACE module, LB algorithm is used and new SSL connection is initiated to the rserver.Standard operation works without problems.Bu...

hello , is there an equivalent to group command on ace  to migrate :group group_nameactiveadd destination service service_name1add destination service service_name2add destination service service_name3Thanx for your support;

Hi ,Could some one explain "sh arp" command in ACE.Example: ================================================================================IP ADDRESS      MAC-ADDRESS        Interface  Type      Encap  NextArp(s) Status==============================...