loadbalance for servers thats belongs from different Vlan

[ranjith.kanisan]

Hi,

We are using FWSM and ACE module in our switch. We have to configure our new application in cisco ACE. Our exiciting servers and vip are in vlan5 and new servers and vips are in vlan 6. vlan 6 is defined in FWSM. We have craeated one interface vlan 6 for the application. While checking the interface status  through "show interface vlan 6" we are getting the following error.

  Not assigned from the Supervisor, down on Supervisor

We have already assigned vlan group to supervisor. We have allocated same interfce vlan to context also.

kindly suggest what chould be the issue.

Kindly suggest can we do the loadbalance for servers thats belongs from different Vlan???

Thanks in advance.

Regards,

Ranjith

[Daniel Arrondo Ostiz]

Hi Ranjith,

As the error message specifies, vlan 6 is either not  assigned to the ACE on the switch or the vlan itself is down (which can  happen if it's not defined, it has no ports associated to it....)

You should review your switch configuration, because you may have made a mistake.

Regards

Daniel

[ranjith.kanisan]

Hi Daniel,

Thanks for the responce.

We have defined vlan 6 in FWSM. Because of that we have administratively down the vlan 6 in switch. Please find the below output for your reference.

firewall multiple-vlan-interfaces

firewall module 1 vlan-group 1,3

firewall vlan-group 1  4,6-12,15,16

svclc multiple-vlan-interfaces

svclc module 2 vlan-group 2,3,4,5,6

Kindly suggest how we can do the loadbalance for those servers from vlan 6.

Regards,

Ranjith

[Daniel Arrondo Ostiz · Accepted solution]

Hi Ranjith,

This doesn't change what I mentioned.

First of all, you added to the ACE a vlan-group number 6, but you would need to confirm if vlan 6 is in fact member of that vlan-group or not.

The second thing is whether the vlan (the L2 vlan, not the L3 vlan interface) is up on the switch. You can use the "show vlan id 6" command to verify if that's the case.

Daniel

[ranjith.kanisan]

Hi Daniel,

We are using cisco 6509 switch with FWSM and ACE module.

We have created interface VLAN 6 in FWSM and ACE and assigned the IP as follows.

FWSM Interface VLAN 6 is 10.6.10.55 and ACE Interfce VLAN 6 is 10.6.10.60.

We have 2 servers in the same vlan (.49 and .50). and they are physicaly connected to switch vlan 6 and logicaly connected to FWSM interface vlan 6.

We have defined the VIP as 10.6.10.51 and that is not pinging from our network.

Server default gateway and ACE default gateway is FWSM interface vlan 6 IP(ie, 10.6.10.55).

We dont want to change the server gateway as ACE interface vlan 6 ip.

KIndly suggest how can i achive the loadbalancing with out changing my server gateway to ACE IP.

Thanks in advance.

Regards,

Ranjith