Application Networking

Hi,I need to do load balancing of 2 servers which are in LAN over UDP 1024 port.I need following.1. Server should be load balanced on UDP port 1024. VIP is 172.24.7.482. When connection initiating from internet Clients for website request should take...

HiIs there any way to keep real server IP address as source in the requests instead of VIP in CSS configuration.Thanks Shanil

Hi,We are getting "Network interface error on WAE -674 ". By doing self-diagnostic test the alarm , the alarm is for Gi 2/0 on the WAE which is down as per WAAS CM.This interface is not in use and the primary-interface for the WAE is Gi 1/0.When I tr...

Hi We got clients accessing a page loadbalanced on our Ace 4710. Users access this page https://hostname.domain.net/Reports  we want this to be rewritten to https://hostname.domain.net/Reports/Page/Folder.aspx is this possible to do on the ace? confi...

hIJust done a course on the ace and seem to be having some trouble with the virtual sideof things. I am trying to work out why i cant ping out of my virtual instance Testing-11I have set up the following vlan ....vlan 1000 10.x.x.21 255.255.255.0Howe...

Can I specify a timeout value for the sticky layer4payload,will the timeout value work for this stickyI was unable to find the documentation on this.Please advise me

Hi,We replaced a WAE-474 yesterday. After the installation of the new device, I recovered the running-config for this device from WAAS CM. Unfortunately, SSH service is not enabled  on the new device and at the same time telnet is also disabled.The d...

Our Exchange 2010 hub servers run multiple services/ports:  smtp, www, pop3,135, 143, https, 993, 995, 6001,6002,6003,60200,60201,8400, and 8402what is the best way of balancing these servers so that if only one of the services failed on a server, it...

Hi,I have an HA ACE deployment and all seemed to be working well until I tried to access the ACE via the management VLAN in the one non-system context, no go.The ACE is in one-armed mode with an Admin/System context and one user context (named Messag...

I am trying to upgrade a DCNM Linux installation and I can't get DCNM to stop to perform the upgrade.I have tried to stop it using both normal user and root but I get the following message:[netops@dcnm1 init.d]$ ./jboss stopJBOSS_CMD_START = cd /usr/...