07-02-2012 10:27 AM
i have cisco catalyst 4506 switch and i run no logging by mistake and i am trying to enable logging again but not displayed at all
07-02-2012 03:34 PM
logging enable
07-03-2012 02:25 AM
yes logging on
every thing is enable but no loggin messge appears only specific types of messages not all
07-03-2012 02:38 PM
Yoy need to set the level of messages
type in "logging buffered ?"
then choose level as below
<0-7> Logging severity level
<4096-2147483647> Logging buffer size
alerts Immediate action needed (severity=1)
critical Critical conditions (severity=2)
debugging Debugging messages (severity=7)
emergencies System is unusable (severity=0)
errors Error conditions (severity=3)
informational Informational messages (severity=6)
notifications Normal but significant conditions (severity=5)
warnings Warning conditions (severity=4)
07-03-2012 03:09 PM
every thing is enable but no loggin messge appears only specific types of messages not all
What specific loggings are you looking for?
By default, interfaces on line cards for 4500 and 6500 are disabled.
To enable it, you need to go into the interface-level and enter the command "logging event link-status". When you enable this command everytime the interface would go either down or up you'll see a few lines appear in the logs.
07-06-2012 11:05 PM
i already enable debugging level but not diaplayed
07-06-2012 11:54 PM
"logging event link-status"
Have you tried this interface-level configuration command?
07-07-2012 11:17 PM
i will enable logging event link-status but what about other notifications
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide