09-21-2012 02:43 AM
Hi,
Does anyone know how to enable maintance-mode in ACE and any disadvantages to enabling it in ACE-30 blade.
ACE-30/Admin#sh ft group 2 status
FT Group : 2
Configured Status : in-service
Maintenance mode : MAINT_MODE_OFF <--------------------------------
My State : FSM_FT_STATE_ACTIVE
Peer State : FSM_FT_STATE_STANDBY_HOT
Peer Id : 1
No. of Contexts : 1
Running cfg sync status : Running configuration sync has completed
Startup cfg sync status : Startup configuration sync has completed
ACE-30/Admin#
Regards,
Solved! Go to Solution.
09-21-2012 10:01 AM
Hello Mohammed-
You can not configure maintainence mode, it is an automatic state controlled internally to indicate error conditions. Here is the information on the different states and why they are triggered:
Maintenance mode: Current maintenance mode of the local context in an FT group. Applications can turn on maintenance mode when there is an inability to communicate with the peer, license mismatches, too many application errors, and so on. Possible states are: •MAINT_MODE_OFF Maintenance mode is turned off. •MAINT_MODE_PARTIAL All standby contexts transition to the FSM_FT_STATE_STANDBY_COLD state (see the “My State” field description). The ACE enters this mode if configuration synchronization fails. •MAINT_MODE_FULL All contexts on the ACE become nonredundant causing their peer contexts to become active. The ACE enters this mode just before you reboot the module and is
Regards,
Chris Higgins
09-21-2012 10:01 AM
Hello Mohammed-
You can not configure maintainence mode, it is an automatic state controlled internally to indicate error conditions. Here is the information on the different states and why they are triggered:
Maintenance mode: Current maintenance mode of the local context in an FT group. Applications can turn on maintenance mode when there is an inability to communicate with the peer, license mismatches, too many application errors, and so on. Possible states are: •MAINT_MODE_OFF Maintenance mode is turned off. •MAINT_MODE_PARTIAL All standby contexts transition to the FSM_FT_STATE_STANDBY_COLD state (see the “My State” field description). The ACE enters this mode if configuration synchronization fails. •MAINT_MODE_FULL All contexts on the ACE become nonredundant causing their peer contexts to become active. The ACE enters this mode just before you reboot the module and is
Regards,
Chris Higgins
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide