03-14-2012 06:27 AM
Hello,
Could someone explain me what is correct steps to clearing
catalyst 6513 configuration from CSM module sections, please?
I am planning to migrate from CSM to ACE module in 6513 and
interesting if is it safe just to do the following:
1) powerdown CSM module with command:
no power enable switch 1 module 3
2) clear in 6513 configuration CSM sections starting from
line "module ContentSwitchingModule 3"
Is that enough to clear CSM configuration?
Also to return the CSM module back to the service will it be enough just
to restore cleared config's sections and power on the module again?
Thank you in advance.
03-21-2012 11:11 AM
Hello,
Unfortunately, there is no easy way on the CSM to clear or archive configurations, it has to be done by hand. I would suggest copying the running configuration to the disk/bootflash on the sup (copy running disk0:backup.cfg), then deleting the configuration you want to remove. If you need to rollback the config, you can just do a "copy disk0:backup.cfg running-config".
Sidenote - A lot of people ask about the command "clear module csm
Regards,
Chris Higgins
03-22-2012 09:07 AM
Thank you, Christopher for response.
I supposed that there is no easy way to remove CSM module configuration...
BTW, have you ever used the "module clear-config" command.
According to the command description, while this command exists in config, after
removing the module from chassis the related module configuration will be removed also.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: