Application Networking

Hi All,I am currently stuck to setup an automated configuration backup for my ACE Blades.I found a script to backup the ACE from the Cisco ANM box but unfortunately I am not very familiar with Linux.Has someone a hint or already an automated solution...

Hello All,I'm new to the forum.  I am using an ACE 30 module for loadbalancing to two proxy servers.  Not all the traffic needs to be loadbalanced and directed to the proxy servers.  I would like the clients trying to access our intranet and other in...

Am trying to verify performance figures for ACE 4710 as EOL replacement for a CSS 11503 Am sure that the ACE 4710 smokes the CSS but have to complete the due diligencePulling figures from data sheets, release notes etc.. I have only come up with the ...

With the current (A5) ACE 4710 lic setup, does the "X gigabit per second appliance throughput" that is licensed affect: -A)  Only "appliance" i.e. load balancing traffic, any other normal routed traffic is not included in the limit   orB) Is it an ov...

Hi I have a stack of 3750s with IP Services and 2 WAAS appliances connected to the stack. I am running wccp in the stack and redirecting traffic to the WAAS appliances using a redirect acl. I read in the command guide for the 3750 that ONLY permit en...

On our current configuration we do not have this enabled.  We are running version 4.2.3c build 1.   Are we cuurent enough to enable this?  I was reading that you need 4.3 for this to work? Should we be up to a later version?

Hello,Do you know if ACE Module support balance the follow protocols:1. rmis 2. ajp3. jms4. IIOP5. CORBA6. IIOPSI know that ACE module support http, https and tcp/udp port.Best Regards

Q1 - Let say I have 200 sites and divided them into 5 sections, so each section has 40 sites. To share the load, I want to deploy one central manager for each section, so there will be a total of 5 central managers for 200 sites.  Will that be a vali...

Hello,I am running redundant ACE 4710 appliances running A3(2.7).  I have five FT groups configured along with FT Tracking and when the vlans fail due to physical links being down, the contexts to do not failover.  If one of the ACE boxes fail comple...

We have 50 subscriber using Cisco Router 851 can't loading page yahoo. Any suggestion??? help???---Posted by WebUser Huy Eav

Hello,Could someone explain me what is correct steps to clearing catalyst 6513 configuration from CSM module sections, please?I am planning to migrate from CSM to ACE module in 6513 andinteresting if is it safe just to do the following:1) powerdown C...

ACE HTTP Probe with regexHi,I'm trying to setup a HTTP probe with expected string rather then a code (config below). I do a GET for the page then a search for a string in the response however it's not working, as probe appears as failed.I've tested t...

Hi,We have two ACE 30 module in two Cat 6k with multiple contexts. And our requirement is to have both the boxes active for some context. We have configured the ft vlan, ft peer and ft group for each context on ACE level. And on Cat 6k, L2 vlan is cr...