Problem redirecting HTTPS trafic using WCCP on a Cisco 6509

[michaeljensen]

Hi

I am implementing af Ironport web scanning solution in a current network and i have som problems with HTTPS trafic.

I am using the following command.

-------------------------------------------------------------------------------

ip wccp 70 group-list 9 password xxx accelerated

interface Vlan2

      ip wccp 70 redirect in

access-list 9 permit <Ironport IP>

-------------------------------------------------------------------------------

on the Ironport the "Dynamic service ID" of 70 is configuret to accept port 80 and 443 but i only recive port 80 trafic, but if i use windows proxy settings to direct the trafik i recieve trafic from both ports.

So i think the problem is in my WCCP configuration.

[Ahmad Basel Jaber]

Can you reset the WCCP session between the Ironport and the 6K, SPAN the interface where the Ironport is connected, re-establish the WCCP session and collect the captures in pcap format, then upload them?!

Can you get the show ip wccp commands from the 6K to check the WCCP status?