Ready_to_test still I have connection

irodi · ‎12-16-2005

Hi,

I have a cisco 7606 with ios slb, and I have a server farm with two reals. The probe is ping and both are operational. What happen is that some time one of the reals goes in Ready_to_test, still the real is operational. I put one of the real no inservice, so the only real was the one with state Ready_to_test. I did the connection and everything goes ok , but if i do "show ip slb serverfarm name A det, the real results Ready_to_test.

Is this a bug?

What's happen?

Thanks

Ira

Gilles Dufour · ‎12-19-2005

You must run traffic successfully through the real to leave READY_TO_TEST.

If the traffic is unsuccessful, then it goes to FAILED after the faildetect threshold is exceeded.

irodi · ‎12-19-2005

Hi Gilles,

thanks for your answer. We run successfullythrough the real but It still remain on the state Ready_to_test. I thought this is a bug and I find CSCsb14185. Do you think this is our case?

Thanks

Ira

Gilles Dufour · ‎12-20-2005

CSCds15582: FWLB: Real stuck in READY_TO_TEST state

could be this one.

I do not have your entire config and your software version, so hard to tell.

Gilles.