cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1288
Views
0
Helpful
4
Replies

Replacing disk on wae612

Kashish_Patel
Level 2
Level 2

One of the disks in our WAE-612 has failed and I have to replace it.

While checking the replacement procedure at

http://www.cisco.com/en/US/partner/docs/app_ntwk_services/waas/waas/v431/configuration/guide/maint.html#wp1139597,

I see a point

"

Step 2

Insert  a replacement disk into the slot in the WAE. The replacement disk must  have a disk ID number that is different from the disk that it is  replacing. "

Question is how will I check disk ID of the failed disk and of the new disk that I am going to put in? Is disk00,disk01 etc disk IDs? How to make sure that the new disk has a different disk ID than the one which has failed?

Thanks,

Kashish

4 Replies 4

Felix Arrieta
Cisco Employee
Cisco Employee

you can do #show disks failed-disk-id   to check the failed disk ID,  I don't recall if there's a label or something from the new disk with it's ID... in any case if you're having issues with the rebuild not starting or the WAE not being able to recognize the new disk, please follow the steps on the link below, also insert the new disk or a different slot.

612WAE hard disk replacement:

http://docwiki.cisco.com/wiki/Cisco_WAAS_Troubleshooting_Guide_for_Release_4.1.3_and_Later_--_Troubleshooting_Disk_and_Hardware_Problems#Replacing_Disks_on_the_WAE-612_with_WAAS_Versions_4.0.11_and_Earlier_Releases

regards,


Felix,

Here is the o/p of "show disks failed-disk-id"

waas#sh disks failed-disk-id

Disk location   Serial Number

disk00          J80FRFXK

Is disk00 the disk ID here? How should I check what is the disk ID of the new disk?

Thanks,

Kashish

Also the document mentions

Versions 4.0.11 and Earlier Releases

whereas we are running

Version: oe612-4.4.5c.4

Can some body please answer the question for me?

PS: I rate useful posts

Review Cisco Networking for a $25 gift card