Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Hi,I have a config which has been working well  for many years.Now i change the management class and after it i can access the ACE. ( I remove and applied the management service-policy also )Telnet, SSh, ping are not working. I change back the config...

hello, when xff is inserted in http header by ace 20/30is it done in data plane ( hardware ) or in software ?just to know if CPU will be impacted by this .Thanx for your answer.

fd_case17 by Level 3
  • 708 Views
  • 1 replies
  • 0 Helpful votes

I am looking at deploying a redundant, load balancing WAAS solution at a Data Center.Hardware:2 x 694 WAE's Application Accelerators1 x 294 WAE Central Manager2 x 6506 Catalyst core switches running VSS2 x 3925 ISR WAN routers connecting to seperate ...

Jovan Bogoev by Community Member
  • 2447 Views
  • 1 replies
  • 0 Helpful votes

Can somebody tell me what is the procedure of replacing a faulty disk on WAE512?As WAE512 does not support hot swap functionality, so I think this should be done:Physically power off the devicetake out faulty diskinsert new diskpower on the deviceCou...

Hi expert,              I can't ping the VIP address from other vlan servers. Though VIP is showing inservice and no ACL is blocking any traffic.access-list INSIDE remark ACL to open access for L-3 routing of non-LB flowsaccess-list INSIDE line 10 ex...

Hello everybody!We have a problem connecting to VIP configured on Cisco ACE20 module installed in 6509 from remote clients. Clients are connected to our core network over IPSec or GRE tunnels (MTU less than 1500). Investigation and traffic dump readi...

pbijiko76 by Community Member
  • 1961 Views
  • 4 replies
  • 0 Helpful votes