Hello WAAS Experts,Can Cisco WAAS communicate with Juniper WAN Optimizer? If so, which Cisco and Juniper hardware models?Thank You,Audie
Forum Posts
CP 8841, CP 8811 Authentication Failure, new ip phone, when i open authentication from switch port configuration its working, with authentication its not working , status showing unauthentication.
Consider that L3Out Link is not yet in Place between PRD Tnt to ISN RTR ( at left side of the Diagram ). I am evaluating the situation if I bring the L3Out Link between DR PRD Tenant to ISN RTR. At DR Site PRD Tnt through L3Out it will receive Route ...
Hi Community,We have recently installed new N2K-C2348UPQ-10GE FEXs, however they are not coming online.The interface is showing :Ethernet1/21 is down (SDP timeout/SFP Mismatch)and the fex logs: [26209]04/21/2026 21:27:31.692130: fport [0x1a014000]:L...
all the vms on the esx restarted after deployed NDFC . it disables the access to the storage any idea ? ESXi vmware , the hardware is DELL MX 760
Hi, I am looking to obtain the ECCN's for the noted products, can someone please help with my request.Meraki:ECCNs for the following: MR44 WiFi 6 Indoor APLIC-ENT-5YR MR Enterprise License, 5YRMS250 Managed Ethernet SwitchMS250-48LP 48 Network, 4 Upl...
Resolved! C9350-24T
Hi,I need HTS, ECCN and ANSSI Autorisation for CISCO 9350-24T,please
Hi friends, I'm trying to configure the DNA with the Cisco 9300. Please do you have a guide on how to do it, as the configuration doesn't seem very user-friendly. I'll be waiting.
Good DayI have a pair of C8200L devices racked and online.These will be running a redundant Call Manager Express install.First I am told I must configure Box-to-Box redundancy.I navigate here but find this document unusable:Home > Support > Product ...
Resolved! ECCN code
Hi,We need HTS, Harmonization Code and ECCN for the following assets CISCO ISR 1100 Series C1121-8P Integrated Services Router
Resolved! HTS & ECCN Code
Hello,We need HTS, Harmonization Code and ECCN for ISR 1100 series C1121-8P
Resolved! Server load balancing onto itself
hiI have a customer with 4710 that load balances inbound traffic onto 2 servers. this worksThere is also a requirement for the servers that are load balnced to [what seems to me ] to load balance onto themselves and for other server on the same vlan ...
Hi, I'm looking for ECCN, HTS/EU Taric codes for the following products: - CW9172I-CFG - C9300-48UN-E & C9300-48UN-A - C9300-NM-8X - C8200-1N-4T - C9300LM-48UX-4Y-E & C9300LM-48UX-4Y-A Can anyone help me on this?
Hi Guys,Wanted to know what was the preferred or Cisco accepted way to install / configure multi-tier certificates on the SSL module? When reading the config guide, it discusses in detail how to handle a single tier cert (i.e just a root ca cert), h...
Hello Expert ,We are replacing the N3K device with N9K .We could see N3K has LAN_BASE_SERVICES_PKG license whereas in new N9K device there is no license ..Will this have any problem after the switch replacement ?N3K : N3K-C3048TP-1GE ...
