SLB on ACE4710 with NAT Client

[ajtm]

I'm trying to do souce NAT (NAT client) using an IP address from server side but it isn't working. I think I can use the same multi-match policy to do both NAT and SLB but I'm not sure..

Please see attached config.

Thanks

[Gilles Dufour]

The config looks good.

What version do you run ?

Check my blog to find procedures to troubleshoot your issue "https://supportforums.cisco.com/community/netpro/data-center/application-network/blog/2010/11/25/datacenter-troubleshooting-guide--day-3"

Check if the nat pool was correctly programmed in DP.

How do you know that does not work ?

Do you have a sniffer trace ?

Gilles.

[Thompso7540_2]

is it ok to nat to an IP in the server side vlan? Would it be better to just nat to the VIP which is part of the client side subnet?