I am unable to enter config mode on an active ACE module.
Also, I don't even have the option for any 'sh ft' commands.
It might be an authorization issue with ACS but it doesn't give a 'command authorization fail' message when trying the command.
changeto Changeto another context
configure Enter configuration mode
dir Directory listing for files
exit Exit from the EXEC
ping Send echo messages
show Show running system information
ssh SSH to another system
terminal Set terminal line parameters
traceroute Trace route to destination
xml-show Display xmlized show command result in xml
% invalid command detected at '^' marker.
Does this look like an authorization issue?
The problem is the Role of the user you are using, is probably a network-monitor role. You can check with show users to confirm this.
You probably need to setup the shell attribute in the ACS