unable to view logging information on the context

[kalugotla1]

Unable to see the ogging message on the user context on ACE,but able to view the logging on the Admin Context.

Admin# sh logging

Message logging:                none

Buffered logging:               enabled (level - debugging) maximum size 1048576

Buffer info: current size - 1048576 global pool - 1048576 used pool - 1048576

                min - 0 max - 1048576

                cur ptr = 916918 wrapped - yes

messages are displayed on the logging screen

production# sh logging

Message logging:                none

Buffered logging:               enabled (level - information) maximum size 0

Buffer info: current size - 0 global pool - 1048576 used pool - 1048576

                min - 104448 max - 0

                cur ptr = 0 wrapped - yes

on the production context  cur ptr=0 and  no message are displayedon the screen

not sure if I am missing any config

[kalugotla1]

No logging message on ACE ,these are the commands issues on ACE

logging enable

logging fastpath

logging console 6

logging timestamp

logging history 7

logging buffered 7

logging monitor 6

This is the output I am getting

ace2/Admin# sh logging

Syslog logging:                 enabled

Facility:                       20

History logging:                enabled (level- debugging)

Trap logging:                   enabled (level - information)

Timestamp logging:              enabled

Fastpath logging:               enabled

Persist logging:                disabled

Standby logging:                disabled

Rate-limit logging:             disabled (min - 0 max 100000 msgs/sec)

Console logging:                enabled (level - information)

Monitor logging:                enabled (level - information)

Device ID:                      disabled

Message logging:                none

Buffered logging:               enabled (level - debugging) maximum size 0

Buffer info: current size - 0 global pool - 1048576 used pool - 0

                min - 0 max - 1048576

                cur ptr = 0 wrapped - no

ace2/Admin#

[Andrew Nam]

I think your colleague opened a TAC case for this. So we checked the ACE via Webex session and this ACE is configured as a FT standby and the peer ACE running as Active. The peer Active ACE is not configured with any logging cmds.

regards

Andrew