01-05-2016 08:39 AM
Hi,
When I attempt to upgrade a 594 AppNav controller from 5.5.3 to 6.1.1, I receive the message "UPgrade of WAVE configured as apnav-controller is not supported to WAAS -6.x"
Has anyone run into this and how did you resolve this? I was thinking I could change the device mode via CLI, upgrade it, and then change the device mode back. TAC mentioned to me that I should check to see if the BIOS and BMC hardware would need to be upgraded, but I verified the version numbers and we are at the correct version.
Thanks,
Solved! Go to Solution.
01-05-2016 11:44 PM
Hi Charlie,
as per the release notes the APPNAV device mode is no longer supported - quote :
– Debug feature for AD trace handling
– AppNav controller device mode
– CIFS application accelerator and CLI commands related to the CIFS AO
– Video application accelerator and CLI commands related to the video AO
– Virtual blade and CLI commands related to virtual blade
Maybee TAC should consult the release notes too ;-)
Best Regards
Finn
01-05-2016 11:44 PM
Hi Charlie,
as per the release notes the APPNAV device mode is no longer supported - quote :
– Debug feature for AD trace handling
– AppNav controller device mode
– CIFS application accelerator and CLI commands related to the CIFS AO
– Video application accelerator and CLI commands related to the video AO
– Virtual blade and CLI commands related to virtual blade
Maybee TAC should consult the release notes too ;-)
Best Regards
Finn
01-06-2016 05:26 AM
Thanks Finn. After several email exchanges, TAC found the same information you provided.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide