hello,
I'm working on getting my ACE modules to load balance PPTP traffic between two servers.
In the initial setup I want all traffic to go to one server. Below is my initial configuration but it
just is not working. Does anyone have any ideas on what is wrong with my configuration.
switch-mode
access-list any line 8 extended permit ip any any
rserver host server1
ip address 10.x.x.x
inservice
rserver host ushq-dev-vpn2
ip address 10.x.x.x
inservice
serverfarm host GRE
rserver server11 47
backup-rserver ushq-dev-vpn2 47
inservice
rserver server2 47
inservice standby
serverfarm host PPTP
rserver server1 1723
backup-rserver ushq-dev-vpn2 1723
inservice
rserver server2 1723
inservice standby
class-map match-all GRE
2 match virtual-address 10.x.x.x tcp eq 47
class-map match-all PPTP
2 match virtual-address 10.x.x.x tcp eq 1723
class-map type management match-any REMOTE_ACCESS
2 match protocol telnet any
3 match protocol icmp any
4 match protocol snmp any
policy-map type management first-match REMOTE_MGMT_ALLOW_POLICY
class REMOTE_ACCESS
permit
policy-map type loadbalance first-match GRE-Policy
class class-default
serverfarm GRE
policy-map type loadbalance first-match PPTP-Policy
class class-default
serverfarm PPTP
policy-map multi-match VIPs
class PPTP
loadbalance vip inservice
loadbalance policy PPTP-Policy
loadbalance vip icmp-reply
class GRE
loadbalance vip inservice
loadbalance policy GRE-Policy
loadbalance vip icmp-reply
class class-default
interface vlan 501
access-group input any
service-policy input REMOTE_MGMT_ALLOW_POLICY
service-policy input VIPs
no shutdown
interface vlan 525
no normalization
no icmp-guard
no shutdown
ip route 0.0.0.0 0.0.0.0 10.x.x.1
