WAAS Design
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-04-2008 03:33 AM
I am designing a WAAS solution for a customer, I am using the WAE-512 with WAAS license in the head quarter and the 2811 WAAS bundled ISR (CISCO2811-WAE/K9)in the branches. Shall I add a WAAS bundle router in the HQ along with the appliance?
I have attached the BoQ.
- Labels:
-
Application Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-04-2008 09:03 AM
Manar,
If you are using an external appliance at the head end, there is not need for the router bundle as well.
Zach
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-04-2008 10:04 PM
Hi Zach,
Thank you for your reply.
The reason that i have asked that question because in the data sheet it is mentioned that the WAE-512 doesn't include Cisco ACNS Content Router.
Please advice.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-05-2008 05:53 AM
Are you planning to use the WAEs for WAAS or ACNS? The content router device mode is only available with ACNS.
Zach
