WAAS optimisation between different WAAS OS versions
We are replacing WAAS devices WAVE - 7371 with WAVE - 7541. There are 6 WAAS devices at this location and we have already replaced one of existing 7371 with 7541. The 7541 are running OS 5.0.3 as we are running OS 4.4.7 on WAAS CM and WAAS devices at other locations (200+) we have not yet enabled wccp on the new device and not registered this device in WAAS CM.
In next few days, we have to upgrade all the 7371 with 7541. I would like to know , if the traffic optimisation will happen between the WAAS devices running 2 different WAAS OS versions.
I don't want to downgrade the OS on 7571, WAAS devices in other location will be upgraded to OS 5 after few months.
Unfortunately, we cannot hold replacing the WAVE 7371 devices till the upgradation of WAAS CM. As we need to return them to the vendor .
As a work arround, can I replace them with 7541 and enable optimisation without registering the WAVE 7371 in the WAAS CM,till the we get approvals for upgrading the WAAS OS ver 5 on remaining ( 200 +) devices including the WAAS CM
It will still optimise the traffic between WAAS devices at other locations right ?
Good afternoon Friends, these days I was accessing the DNAC manager and my surprise is that I did not have access, after a basic analysis I observed that the equipment was operational, but without being able to access it via DNA GUI (browser) I also ident...
Today we are going to talk about how to configure backups in the Cisco ACI APIC Dashboard. As you might know APIC is a UCS based CIMC controller and we can check the configuration backups on the Cisco ACI APIC Dashboard. Remember that the HA solution mus...
Listen: https://smarturl.it/CCRS9E14 Follow us: https://twitter.com/CiscoChampion
Organizations are undergoing digital transformation like never before. Global spending on digital transformation of business practices, products, and organization...