We try to install OS thru CD waas-rescue-cdrom-4.4.5c.4-k9.iso in 2 WAVE-574 for prepare for the customer production environment.
Unfortunately both appliance can't reach boot menu, we try to burn a lot of CDs, but the problem seems to be with version 4.4.5 and something with our hardware:
Attached scsi removable disk sdc at scsi4, channel 0, id 0, lun 0
sd 4:0:0:0: Attached scsi generic sg3 type 0
Cannot determine boot device!
Platform initialization failed.
Please contact Cisco TAC for assistance.
Rebooting in 30 seconds....
We try to install thru rescue CD with 2 different OS and all terminate with successfull!!!
waas-rescue-cdrom-4.3.5.7-k9.iso
WAAS-4.1.5f.2-rescue-cdrom-K9.iso
I upgrade thru FTP Image file .bin
WAVE-574I#copy ftp install 10.0.0.1 \ waas-universal-4.4.5c.4-k9.bin
Enter username for remote ftp server: cisco
Enter password for remote ftp server:
Initiating FTP download...
printing one # per 1MB downloaded
Sending: USER cisco
Hello, I'm freeFTPd 1.0
Password required for cisco
Sending: PASS *****
User cisco logged in
Sending: TYPE I
TYPE set to BINARY
Sending: PASV
Entering passive mode (10,0,0,1,213,254)
Sending: CWD \
CWD command successful
Sending PASV
Entering passive mode (10,0,0,1,213,255)
Sending: RETR waas-universal-4.4.5c.4-k9.bin
Opening BINARY mode data connection for waas-universal-4.4.5c.4-k9.bin (293478486 bytes)
Backing up existing version WAAS 4.1.5f-b2, built on 12:26:34 Apr 20 2010 by cnbuild
Converting Manifest files ... Done
Rebuilding image based on current software ... Done
Backing up flash configuration ... Done
Reclaiming unused flash safe state sectors ... Done.
########################################################################################################################################################################################################################################################################################
Detected OE574
Installing phase3 bootloader...
Installing WAE 64-bit image.
Installing system image to flash... ......................................................................................................................................................................................................... done.
The new software will run after you reload.
WAVE-574#sh flash
Pending software change will occur on next bootup.
Information that follows is for the new software that will run.
WAAS software version (disk-based code): WAAS-4.4.5c-b4
System image on flash:
Version: 4.4.5c.b4
System flash directory:
System image: 201 sectors
Bootloader, rescue image, and other reserved areas: 41 sectors
256 sectors total, 14 sectors free.
At the reload this is the same issue:
Creating device file for IPMI..
Cannot determine boot device!
Unrecognized or non-functioning hardware. Initialization cannot proceed.
Unrecognized or non-functioning hardware. Initialization cannot proceed.
Unrecognized or non-functioning hardware. Initialization cannot proceed.
Which could be the cause that this code can't run in 2 Appliance?
Thanks a lot!