WAVE-694-K9 support vrf?

[Muhammad Hakim]

dear all,

heres my issue, my WAVE-694-K9 encounter an error / not optimizing the traffic. this because i used vrf in WCCP router to redirect traffic to same destination with 2 sub interface-- so i need vrf to distinguish, from source 'a' destined to subinterface 'a' and from source 'b' destined to subinterface 'b'. before i implement the vrf in WCCP Router, the traffic is optimized. so, in my thought that vrf isnt support WAVE-694-K9. is that true?

or can i use the command " ip wccp vrf [vrf-name] " in router WCCP? so the WAVE-694-K9 know wccp redirect vrf.

thanks for any advice.

[Balakrishnan Rajvel]

Hi,

You need to dedicate one WAAS appliance per VRF.or WCCP can be used with a route-leaking option as long as there are no overlapping IP addresses

Refer #

http://www.cisco.com/en/US/prod/collateral/contnetw/ps5680/ps6870/white_paper_C11-560131.pdf

Regards,

Bala