Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have two N7k and I want to configure two VDC each VDC has different VTP and enable OSPF between the two VDCs by using four links my questions are:
All,I am planning to upgrade ten WAE 512 units from 4.4.5 to 4.4.7 and would like guidance from the forum here on how best to accomplish this. I understand that the Central Manager can be used to mass deploy the software and upgrade the appliances a...
All,When trying to view the system image file on a WAAS unit by entering the command "show flash" or "dir" I see a listing of files but none of them appear to be the system image. My goal is to see the actual system image file name in full to determ...
Hello all!I have simple serverfarm with one primary rsyslog and one backup-rsyslog configured. Failaction is configured to purge. When primary goes down all connections are correctly reset and newly pointed to standby unit (backup-rserver) which beco...
Hi all,If there is anyone out there thant can help me with this issue it would be greatly appreciated.One ACE Load balancer, balancing HTTPS traffic to a few servers. Need to insert a x-forward-for on every packet.To my limited knowledge, this can b...
Hi all, I have a problem regarding configuration of certificates on ACE, I have one serverfarm with two realservers, those server runs three different domains on same VIP (Apache handle which one is presented to the user), we want to put https to tho...
Hi,I have a demand for configuring serversida cookie sticky that includes a path, i.e:/path1/cookie1/path2/cookie2/path3/cookie3does it in the normal"sticky http-cookie cookie1 websticky1""cookie1" take the "/path1/cookie1" into account?Or in essence...
Hello Support Forum Members,i just create some ACL rules in cisco ACE 4710.here are some rules,class-map type http inspect match-any DENIED_URL 2 match url .*.exe 3 match url .*.php 4 match url .*.asp 5 match url .*.aspx 6 match url .*.cgi 7 ma...
I attempted to register a WAVE694-K-9 (running code 5.1.1.16) to our Central Manager (OE294 running code 4.4.5) but the registration failed due to a code mismatch between the two units. The rest of the remote WAAS units (OE512's) are running 4.4.5 o...
Hi,So i'm looking at header-inserts on the ACE. We have a requirement to to instruct the ACE to redirect from HTTP to HTTPS should a HTTP request be made. This is fine and has been implemented, however, after the redirect we need to insert an header ...
Hi Allwhen i am trying to install Waas Network module NME-WAE-502-K9 at 2811 router i face a problem when trying to open a session on thr integrated service module as it takes too long time trying to open but no use as follows:Router#service-module i...
Hello,I am trying to redirect inbound connections from http://foo.com to http://foo.com/this/is/a/test 301. The relevant portion of the redirect config is as follows:rserver redirect RD_QA_ANONYMOUS_LOGIN description Redirect Inbound Connections to...
Hey guys,We are using RPC over SSL for Exchange 2013, we have a lot of syslog messages like this:2014 Jan 27 10:15:17 WAAS01 java: %WAAS-CMS-4-700001: Failed to get the encryption/decryption key for EMAPISo it looks like some clients aren't using the...
We're running CSS version 7.50, where the back-end servers r NOT directly connected to it, so used the destination service to NAT them to the VIP, as in the following:group PAD-CAT-PROD vip address 10.2.10.15 add des...
Hello,I recently replaced an older WAAS appliance (OE512?) with a newer and more powerful one (WAVE-694-K9) since the older one was not powerful enough (chronic reports of "Accelerator TFO connection threshold exceeded"). The OE512 was only able to ...
