cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
788
Views
0
Helpful
1
Replies

WCCPv2 on Linux (Gentoo) - Multicast/Unicast Support

dardanarusha
Level 1
Level 1

We need squid cache to communicate with multiple routers. The Squid is working fine with WCCPv2, but, as far as we can see in squid conf, there can only be one wccp2_router directive defined.

When we use wccp2_router the multicast IP address 225.25.25.25 to communicate with group of routers, routers can see the squid, but cannot form service group.

This is a message I get from the Cisco Router:

"WCCP-EVNT:S00: Here_I_Am packet from 80.x.x.x w/bad rcv_id 00000000"

Can squid communicate with multiple routers using WCCPv2 (multicast or unicast)? Has anybody implemented a similar scenario?

Thank you in advance,

Dardan

1 Reply 1

bbaley
Level 3
Level 3

I don't think squid can communicate with multiple routers using WCCPv2

Review Cisco Networking for a $25 gift card