cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
223
Views
0
Helpful
4
Replies
Highlighted
Beginner

web/mail server issue

Dear Sir,

I have a pair of 11501 and need to load balance a pair of web/mail servers. Below is the reloated configuration on one 11501.

interface e3

bridge vlan 30

interface e8

isc-port-one

!************************** CIRCUIT **************************

circuit VLAN10

ip address 10.106.13.250 255.255.255.192

ip virtual-router 10 priority 120 preempt

ip redundant-interface 10 10.106.13.249

ip redundant-vip 10 10.106.13.224

circuit VLAN30

ip address 10.106.13.18 255.255.255.248

ip virtual-router 30 priority 110

ip redundant-interface 30 10.106.13.17

!************************** SERVICE **************************

service PISWEBP01

redundant-index 31

ip address 10.106.13.20

active

service PISWEBP02

redundant-index 32

ip address 10.106.13.21

active

!*************************** OWNER ***************************

owner PIS_PISWEBP0102

content PIS-DNS-VIP-1

vip address 10.106.13.224

port 53

protocol tcp

redundant-index 35

add service PISWEBP01

add service PISWEBP02

active

content PIS-HTTP-VIP-1

vip address 10.106.13.224

port 80

protocol tcp

redundant-index 33

add service PISWEBP01

add service PISWEBP02

active

content PIS-SMTP-VIP-1

vip address 10.106.13.224

port 25

protocol tcp

redundant-index 34

add service PISWEBP01

add service PISWEBP02

active

Vlan10 is the external interface and web servers are connected to vlan 30.

We found that all none of the below works.

1. web

2. DNS lookup

3. SMTP

Any idea?

Thank you!

4 REPLIES 4
Highlighted
Beginner

you are missing vlan 10 on an interface

Highlighted

Sorry, it is there as show below.

interface e1

bridge vlan 10

I missed it in the previous message.

Any idea?

Thanks.

Highlighted
Beginner

1. What does the "show virtual-routers" command output says? Is the same CSS active for both virtual routers (front and back)?

2. Where do clients reside? Do you have a default route on CSS?

3. What does the "show service" command output says?

Best regards,

Jasmina

Highlighted

Hi Jasmina,

The information you need is attached.

e1 is the external interface.

e3 connect to a vlan for web servers.

Thanks a lot.

This widget could not be displayed.