Application Networking

Hello! Is available 2 wae-612 (accelerator) and 1 wae-512 (CM) It is impossible to start in any way them in work. The scheme: net1 - freebsd1 - internet - freebsd2 - net2 .........wae1..................wae2 the Traffic on wae from freebsd is transfe...

I am migrating from a CSS environment to an ACE module in a 6513. I have an ACE context between VLAN29 and VLAN30 that is a DMZ. VLAN29 faces the firewalls and VLAN30 the real servers. I can access the servers with a serverfarm and a "vip". I need to...

What is the recommendation to achieve high availability (and load sharing?) using two WAE's in a DC with inline adapters being used for interception rather than WCCPv2? Any ideas greatly appreciated.

After the WAASs implemented in our site, I have showing up the WAAS standard report to manangement, but they want to have a report to see any improvement on the WAN in between 2 sites.Anyone know that which report or How to present the improvement af...

Hi,We have a couple of 11503 set in an active-backup configuration with fate sharing.They run NAT sucessfully changing web caches ips (behind the CSSs) into CSS redundant VIP when sending responses back to the clients, but sometimes, following a burs...

on CSS I get an info if a server fails the keepalive and get in state "down, up or suspended". This is logged in the traplog file on the CSS.Is there any possibility on an ACE to have logs for rserver state changes like "PROBE-FAILED, OPERATIONAL and...

Dear Folks,I 'd like to load balance 2 ASA using 3 ACE [ Inside,outside,dmz network zone]I 've seen sample configuration, all of them are running the ACE in the route mode, and asa are running in route modeWould it be possible to run the ACE in the b...

I have removed some of the network commands in my bgp router and when re-entered I do not see the whole command ie.beforebgp 654321network 10.1.1.1 mask 255.255.255.0after bgp 654321network 10.1.1.1why is there no mask statement in my command

Dear All,I have to provide ACE loadbalancing for a new multitier application which has server-to-server loadbalancing.The user communicates with loadbalanced webservers which in turn communicate with loadbalanced application servers. I don't have th...

10.176.56.113 and 10.176.56.114 are 2 x DNS servers in Site 1. We are planning to put in 10.188.56.49 and 10.188.56.50 which are Site 2 DNS servers as standby realserver because there was a time when 2 of the Site 1 DNS servers went dead and there wa...

%SERVICEMODULE-2-IPCONFIGFAILED: Service module Integrated-Service-Engine1/0 IP configuration (internal) failedNME-WAE-502-K9 Cisco Wide Area Application Services Software Release 4.0.17 (build b14 Feb 27 2installed in a:Cisco 2800 router:Cisco IOS S...

Dear Sir,I have 2 x 11501 in front of 2 x web server. Now we need the web server act as smtp relay to send outgoing mail.I do not think the mail need load balancing. I found the following configuration does not work. When I execute the "nslookup", I ...

Need some help on why my SQL Probe is not working. Thxprobe tcp MS-SQL description TO-RBSQL1 ip address 10.15.160.3 port 1433 interval 2 faildetect 2 passdetect interval 2 passdetect count 2rserver host RBWEB1 ip address 10.15.177.11rserver h...