According to Intersight link below, "You can choose between the native UCSM Managed Mode (UMM) or Intersight Managed Mode (IMM) for the Fabric attached UCS Systems during initial setup of the Fabric Interconnects. If you choose to switch back between UMM ...
view more
Hallo,i have a project to migrate from Brocade switche to DS-C9148T-24PETK9 Switche.The Server and Storgae are connected redudant to Fabric A and Fabric B. We have 2 Data Center and in every Data Center i want to install 2 Switches.Switche 1 in...
view more
Hey everyone, I am looking for a switch with 48 ports, for my data center.I want each port to have 10gigabit speed, and I don't mind 10GBASE-T copper or SFP+ cabling - or should I?I'm not sure which models support this specification a...
view more
Looking for a little help. Running some B200 M4 blades. Looking to put in 2 x 64GB SD cards. Was told this requires a FlexFlash SD Controller FX3. 1. Is this accurate information?2. What is the cisco MPN for the Fle...
view more
Hello dear community,I am currently trying to understand an existing topology and its spanning tree (screenshot attached).This is probably a topology that deviates from best practice.We have two nexus switches and a cat switch in use. nex4(secondary) and ...
view more
