This event had place on Tuesday 22nd, August 2020 at 10hrs PDT
In this session, Cisco Press author and Principal Engineer Omar Santos talks about how to get started and prepare for the CCNP and CCIE Security Certifications. The SCOR 350-701 exam is the required exam for the CCNP and CCIE Security certifications. during the session, attendees have the opportunity to ask questions to Omar in a live Q&A session.
This event provides an opportunity to interact with the author in real time and learn more about him, his story, the story behind his publications, and how he became a renowned expert.
Omar Santos is an active member of the cyber security community, where he leads several industry-wide initiatives and standards bodies. His active role helps businesses, academic institutions, state and local law enforcement agencies, and other participants dedicated to increasing the security of their critical infrastructures. Omar is the author of more than twenty (20) books and video courses, as well as numerous white papers, articles, and security configuration guidelines and best practices. He is a principal engineer of the Cisco Product Security Incident Response Team (PSIRT), where he mentors and leads engineers and incident managers during the investigation and resolution of cyber security vulnerabilities.
The Official Cert Guide series from Cisco Press help you learn, prepare, and practice for exam success. They are built with the objective of providing assessment, review, and practice to help ensure you are fully prepared for your certification exam.
This event was open for everyone, including Cisco customers & partners.
Do you know you can get answers before opening a TAC case by visiting the Cisco Community.
Hi team,We are seeing a strange issue where logs from ISE are showing different MAC address format in Splunk. If we notice the logs on splunk we see few machines are with xx-xx-xx-xx format however few are xx:xx:xx:xx format. Could any let me know why is ...
Each time users connect to VPN the Anyconnect installer pop-up before or while the posture scan run, but the newer compliance module has been installed to the endpoint but it still shows the pop-up every time they connect VPN. The existing pre-deploy...
Hi Guys, I'm trying to understand what's happening here. I can see Phase 1 UP, However no traffic flow. I suspect an issue with Phase 2. Following is an output of the below debug commands. This was working perfectly fine. And no change...
Hi Team, We are planning for migrating ACS to Cisco ISE. We have planned to perform the migration using the Migration Tool. I just need a confirmation regarding below points: 1. Is any downtime required for the migration to take plac...