Custom tabs-Need logged in user details

[yogeshshanbhag]

Hi Team,

I have a custom tab in my windows Jabber client and I need to populate the logged in user id in the url.

The sample url used in the custom tab is as given below, but the "UserID" value does not get populated.

Eg:  www.cisco.com/mywebapp.op?url=${UserID}   

Also are there other parameters available to get other user details?

Source:

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/jabber/Windows/9_2/JABW_BK_C9731738_00_jabber-windows-install-config/JABW_BK_C9731738_00_jabber-windows-install-config_chapter_0101.html#JABW_RF_U45614BC_00

Appreciate your help in advance.

Regards,

[Geevarghese Cheria]

Hi Yogesh,

    Sometimes this issue could be because of the bug CSCum05002 that mentions about UserID token is not replaced with the username of the logged in user in URLs. You can check the status of the bug with your CCO id.

Thanks and Regards,

Geevarghese

[yogeshshanbhag]

Thanks for the info Geevarghese.

Are you aware of other parameters that can be used in addition to "UserID" ?

Regards,

Yogesh

[yogeshshanbhag]

The problem was resolved with installation of the newer version on jabber windows client 9.7