PRTG system in place running other sensors on the same host, which are working.  Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes.  Within mess... view more

Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================... view more

Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2... view more

Introduction Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs... view more

Hello!We update our ASA Failover sensor for PRTG.Improve usability.New manuals.You can read about it in attachment file.Download sensor from: http://www.powerc.ru/download/asafailover.zip