Cisco Bug Discussions

This Bug hits 1830 series, too. I've seen this issue in the following release trains, too: - 8.2 - up to 8.2.166.0 - 8.3 - up to 8.3.141.0 - 8.5 - up to 8.5.120.0  

Hi There,   Could there possibly be a better explanation for this bug, it indicate as severity 2 but also indicates "should" not have impact abit miss leading.

The work around is to edit the schedule to monthly and submit and change back to daily however my Recurrence choices of Monthly and Yearly are both grayed out so I am unable to choose them.  I am logged in with root access.  Any other work around?

Will it happen at the time of upgrade or next reboot after upgradation.   And is it in 5508 or in all the controllers ?

The Bug release is not helpful. We are using CSM version 4.11 but the mentioned problem still occurs. 

Hi,  I am getting below error for BYOD on Apple iPhone 5S. "Unable to complete provisioning of your device.Click retry to try again"  Attached is error screenshot. Cisco ISE version is 2.1    It is working fine for other android and IOS devices.   Pl...

Hi,   Does this BUG also affect ISE virtual appliance. Although it states that the BUG is fixed, but there is no mention of specific version or patch in which the BUG is fixed.   Can anyone help with additional information.   Rgds, Aniket

Don't use IPv6. I switched from Automatic to Link-local only (on my AirPort router and my (10.13.4) MacBook/iMac) and then 4.6.* no longer gives me the port-forwarding error.

I want my Cisco phones to get Spanish Labels / User Interface when got registered with CUCM 10.5. Please advise me with the "USER Locale" to be installed on the Call Manager.   With installed locale announcements getting played through the phone and ...

Hello,   I have a ASA-5585 and I see the same error. Maybe I also was affected for this BUG ?     Regards,   Emerson

An ESA PM relayed to us that this bug has been fixed and after testing, we see it still failing.  The bug article says fixed but doesn't mention which version.  Anyone else has it working?

Having an option to remove the Hold button would also be ideal, since this seems to occasionally break calls dialing into a bridge that require a DTMF bridge ID entry.

This is also an issue where certain OSD elements cannot be disabled (ie Microphone mute and camera disconnected).