Hi,
I'm seeing the same behavior on fabric up- and downlinks of FE's in current suggested release. 17.9.5 on 9300 and 9400 switches with DNAC on 2.3.5.5-70026.
sh auth ses int ten1/1/1 det
Interface: TenGigabitEthernet1/1/1
IIF-ID: 0x18033B35
MAC Address: dc0b.0991.9921
IPv6 Address: Unknown
IPv4 Address: Unknown
Device-type: Cisco-Switch
Device-name: cisco C9410R
Status: Unauthorized
Domain: UNKNOWN
Oper host mode: multi-auth
Oper control dir: both
Session timeout: N/A
Common Session ID: 0A02D20A0000EF0C21F29F89
Acct Session ID: Unknown
Handle: 0xdb00013c
Current Policy: BUILTIN_AUTOCONF_POLICY
Port configuration:
!
interface TenGigabitEthernet1/1/1
no switchport
dampening
ip address 10.x.x.x 255.255.255.254
no ip redirects
ip pim sparse-mode
ip router isis
load-interval 30
bfd interval 250 min_rx 250 multiplier 3
clns mtu 1400
isis network point-to-point
service-policy output DNA-dscp#APIC_QOS_Q_OUT
Is this expected behavior?
Regards,
Wouter
