Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Goodmorning,
Status of this bug is termintated, what does that mean? No fixed release or explanation it's working as designed.
Example where you can have this problem, is when you discover a switch witch has a loopback 0 interaface but you want to m...
Hi,
Due to time constraints a rollback was done incorrectly. So after the switch was part of the fabric via LAN automation, the switch config was removed on the CLI (pnpa service reset). So steps as described in DNAC guide where NOT followed removing...
Hi,
I'm seeing the same behavior on fabric up- and downlinks of FE's in current suggested release. 17.9.5 on 9300 and 9400 switches with DNAC on 2.3.5.5-70026.
sh auth ses int ten1/1/1 det
Interface: TenGigabitEthernet1/1/1IIF-ID: 0x18033B35MAC Addre...
Hi,
Goal; I want to bulk import SGT's in DNA center. But i'm having problems with the API.Steps taken:
Try "Get virtual network with scalable groups":
Method: GET
Public URL :https://<ip>/dna/intent/api/v1/virtual-network
Parameter; virtualNetworkNam...
Hi,
I've also seen this behaviour in 10.2(4) and current recommended 10.2(6),
Duplicated in the lab, setup 4 SPF+ 10G interfaces in de same quad (e1/9-12) with qsfp>sfp+ convertor. Logging from connected test switch:
Remove of convertor+10G SFP in Et...
Ok, I just went for it. Deleted it from fabric. It then ofcourse gives an error it cannot communicate with the removed switch. As a result, in the fabric topoligy view the edge node shows as greyed-out. Then I deleted it from inventory. With that las...
Would you apply port 2-event as switch global on all access switches? I've never seen it active in a network config at other customers. (i'm aware of the impact on power budget impact of port 2-event)
