Hi there,
Anyone else has this problem too? We are experiencing the same problem with almost all of our C9300L-48T-4X Switches. the SN Numbers of the Power Supplies are all starting with DCC..... Our Software Version is IOS XE 17.3.4. We already expierenced the problem with IOS XE 16.12.05 and hoped, that an upgrade will maybe solve the problem. But as I see now,
Replacing the Switches & Power Supplies won't help... Always the same problem: Every one to two weeks somebody needs to travel to the switch sites to remove the power cord of the corresponding Power Supply with the following status until the LEDs are off....:
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A PWR-C1-350WAC-P DCC******** Disabled Bad n/a 350
1B PWR-C1-350WAC-P DCC******** OK Good n/a 350
....and then reinsert the power cord again:
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A PWR-C1-350WAC-P DCC******** OK Good n/a 350
1B PWR-C1-350WAC-P DCC******** OK Good n/a 350
until last week the LED of faulty power supply turned to red but today we had a faulty power supply with both LED shining green....Luckely I new already which power supply was the A and whitch the B....
