I have a client running version 5.2(1)N1(8b) and wanted to know if this falls under the affected releases.
Known Nexus 5K affected releases:
Known Nexus 5K fixed releases:
CSCub38654 - N5K Switch hang/lock up may occur due to Leap second update https://tools.cisco.com/bugsearch/bug/CSCub38654
Solved! Go to Solution.
Thanks Mark. I listed the known affected and fixed releases based on the Cisco bugsearch result listed in the question but could not find my exact release. Do you have another source for my actual version 5.2(1)N1(8b) that you could reference?
Hi your client is on the safe harbour image the most recommended one in the train by Cisco , your image is from Nov 2014 the ones effected are a year before it , you will not get any more confirmation other than the bug release , out of all the releases only 2 were effected so it very unlikely there version is as the fix would generally be in newer releases , you can check the release notes caveat section for your version but i dont see any on the Cisco website for these releases
When I go to Cisco's bug search site and enter "leap second" and nexus 5596UP as a product, it doesn't have any reference to the specific version we 5.2(1)N1(8b). Here's the search results I do get:
I'm still not convinced my version is not affected. The ones higher are listed as fixed but no mention of this:
|Known Fixed Releases:|
I have a customer running the same version, 5.2(1)N1(8b) so we're gonna disable NTP as well.
Since we have two Nexus-switches we're configuring in a switch-profile.
However, I'm unable to remove the ntp server when I'm in config sync.
The negate command does not exist.
Nexus-1(config-sync-sp)# no ? cdp Configure CDP parameters class-map Configure a class map clock Clock feature Command to enable/disable features fex FEX configuration hardware Change hardware usage settings interface Configure interfaces ip Configure IP features ipv6 Configure IPv6 features lacp Configure LACP parameters logging Modify message logging facilities mac MAC configuration commands mac MAC mvr-config Enable IGMP MVR policy-map Configure a policy map port-channel Configure port channel parameters port-profile Configure a port-profile slot Configure a slot spanning-tree Spanning Tree Subsystem sync-peers Specify peers to whom configuration needs to be synced system System management commands vlan Vlan commands vpc Vpc wrr-queue Map traffic priority (CoS) values to L3 Multicast Queues
Do I just use conf t and remove the ntp server on both switches?
Since the leap second bug (CSCub38654) is listed as one of the resolved caveats in release notes for 5.2(1)N1(9), it would seem that 5.2(1)N1(8b) would still susceptible to the advisory.