I have a customer who wishes to make the following changes to a live DNAC cluster and would appreciate comments from any one who has done this or knows a bit more than me ....probably everyone
The cusomter want to:
1) Change the 3 CIMC addresses of each of the 3 DNAC nodes in a cluster (address and subnet)
2) Change the 3 Enterprise subnet masks from a /24 to a /28 (not subnet only change the masks)
3) Move from a single Enterprise and cluster port to dual ie enable NIC bonding active/standby to 2 sepatate switches. I read that for brownfield you can't have VLAN over LACP...what exactly is VLAN over LACP and if you can't run this what is the impact?? How do you configure this, since there is no Etherchannel I assume you don't need LACP so what are the config steps (don't need screen shots just what boxes need ticking/no ticking)??
Many thanks
Steve