Hello,
I am running into an issue while trying to setup 1800s sensor in SDA deployment based on DNAC 1.3.3.9.
The sensor registered to DNAC Plug and play page and i was able to claim it using the default settings and backhaul profile successfully.
Once it shows in the sensor list page, the next step is to create a sensor test template, except when i try to do so the SSID selection is empty (See screenshot) even though we have multiple SSIDs defined on DNAc, both fabric and non-fabric.
I've looked through the release notes for our DNAC version and it does not look like there are any bugs related to that behavior.
I'm not sure if that could be some kind of GUI bug or if we're missing a piece of config on SSIDs to make them appear.
Has anyone seen or fixed this issue before ?
Thanks for reading, have a nice day!
