DNAC cannot see clients from Anchor WLC

[craiglebutt]

We have several anchors with differenct organisations.

As a NHS hospital, we have devices in the commuity over local primary care trust wireless network.

We anhcor back to each other.

As our clients authenticate via CAPWAP back to our WLC, get a IP from out DHCP, our WLC says they are on AP  (IP of anchor WLC)

I'm surprised that can't get any info of clients on DNAC for this, Prime shows its conencted and on which AP, DNAC nothing.

Prime running 3.10.2 and DNAC running 2.3.5.5

Is it possible to run reports on these devices with?

[marce1000]

  - Use advisory software version on the 9800 (if used) ; 17.9.5 (e.g.) and check again , 

 M.