I want to know the configuration of the switch managed by DNA Center

[Toru Matsuda]

I SSH into the C9300.When I looked at the Running Config, the content was different from the DNAC GUI.

I was wondering.

Because if someone accidentally changes the config with SSH, DNAC will correct it in about 10 minutes.

I SSH into a switch under control and collected the config.

Is there a way to check if the DNAC has the same information as this config?

[Flavio Miranda]

Hi

 You can look at the compliance, under Inventory. If the information there is "not compliance", means the config between DNAC and device is different.