folks
i'm looking at trex in cml and have managed to generate traffic by connecting the eth1 port onto the same lan as the device i'm testing but i want to push traffic through the device to an endpoint across the wan and so have some questions
- my trex node only show a single port, port 0, in the gui, is that expected
- does trex only work on the lan or can i generate traffic to test across the wan
- do i need to configure a gateway in trex to send traffic over a wan and if so how do i do that
- if can configure the trffic using the gui but can't seem to get into the cli of the trex node to add a route
thanks to anyone taking the time to respond, it's much appreciated
