Anyone else having issues running the breakout tool with the "run" command? This is the output I see on my mac when trying to run it with a single lab created:
% ./breakout run
System version: 2.0.0-b13
+---------+------------+--------+---------+
| NODE ID | NODE LABEL | DEVICE | ADDRESS |
+---------+------------+--------+---------+
+---------+------------+--------+---------+
Running... Press Ctrl-C to stop.
%
Nothing shown and it immediately drops back to the prompt. I can run the "ui" command and the tool works fine. It's just "run" that is doing this using the mac version of the tool
Thanks!