Cisco Modeling Labs Discussions

Anyone else having issues running the breakout tool with the "run" command? This is the output I see on my mac when trying to run it with a single lab created: % ./breakout runSystem version: 2.0.0-b13+---------+------------+--------+---------+| NODE...

Hi there! My company bought the CML enterprise and I'm looking for steps to perform an upgrade. I know I have to do a fresh install. But where do I get the license file? Can I use the .lic file I received when I installed 1.6? Can I export the file o...

Hi All, I suspect unmanaged switch is causing connectivity issues - but I want to get your advice. I have topology consisting of 10 CRS1000v, all connected to single unmanaged switch (via Gi1 on all of them). On the other side, unmanaged switch is co...

I have 2 systems, one at 192.168.10.5 runs a dhcp server, one at 192.168.10.66 runs the CML ova and the UI.  I create a topology under CML which consists of a ext-conn device, an un-managed switch, and iosv device and an iosvl2 device.  All devices a...

Hey guys,do you think it is possible to deploy CML 2.0 in a cloud? Has anyone tried this out yet?Or do you think the licensing could be a problem there? Would I need to revoke my license on my local PC to try it out?If that possible I would be able t...

i am cisco employee, where can download cisco modeling lab?and how much space needed and how to install? if buy it, how much is it?

I booted up the CML 2.0 ova and created a second host only adapter configured as 172.16.2.133.  I was able to ping other VMs on that network.  When I rebooted the VM the CML UI showed that it was accessible via 172.16.2.133 and not 172.16.192.133 whi...

I have a Virl 1.5 license and I am able to get the product key for my CML 2.0 license.  However, it fails to register even though I have Internet connectivity to my VM.  This is a personal license so I would rather not use an Enterprise Smart License...

Im running CML on VMWare ESX and im not been able to get the external connector to work properly on bridge mode. on ESX i have the following options enable but still nothings. The IOU don't get the ARP from the gateway. SecurityPromiscuous mode Accep...

Hello All, Could anyone tell me how I get this fixed please? I have unlicensed all the builds I have done but it still says out of compliance, is there a timer on this? i.e. clears after a period of time or does someone within Cisco need to clear thi...

Hi,There does not seem to be any way to send "CTRL+ALT+DEL" to a node running in CML2 from the WebUI. Whether it would be VNC or a Console enabled node. This would be a very helpful feature, especially when I run Windows Server nodes in a lab, saving...

Hi  is there a way to export the packet capture which is run within the web gui of CML-P to wireshark so i can see more detail about the packets that are captured ?