Multicast Lab Auto-RP

[ftermine83]

Hi ALL,

I have setup a lab in CML for testing multicast using Auto-RP but I cant see traffic flowing from the source to the receivers . I can see the (S,G) entry in the first hop router and the (*,G) entry in the RP .

Appreciate any feedback 

Thanks,

Francesco

[MHM Cisco World]

that what I try to know why, if direct connect then R1 need to know RP IP from R3 not from R2

MHM

[ftermine83]

at the moment R1 is learning the RP from R2 so it should work . I just think it is an issue with CML . I took a packet capture and I dont see the Register message being sent by  R1 when the source start transmitting 

[MHM Cisco World]

To he honest' I run lab abd it work in gns3' but I dont think it CML sunce you mention that you change R1 with NSK and it work' or I am wrong?

MHM

[ftermine83]

Yes If I replace R1 which is IOSv with a Nexus it works . I was saying I think it is an issue with IOSv in CML